Formula Mazda

The series originally grew out of five chassis built by Hayashi in Japan for the Jim Russell Racing Drivers School in California, USA. Unfortunately these cars arrived with defects in the engine bays and gear boxes installed incorrectly. Twenty-five cars were built by Marc Bahner, Bahner Engineering, Calif., for the 1984 Long Beach Grand Prix, where the cars made their US debut. The majority of these cars were purchased by owner/operators. The original five chassis remained with the Russell School. The cars have a basic welded steel tube frame chassis, with in-board front shocks operated by upper rocker arms. A 180 hp carbureted Mazda rotary engine drives through a 5 speed H-pattern (H-gate) Hewland Mk 9 transaxle. Rear suspension is by two trailing links, an upper link and a lower a-arm. In the interest of creating close racing and limiting cost, the rules state that no modification is allowed until the rules expressly permit it—at one time even replacing the mirrors on the car was prohibited. The engines cannot be modified, and they are sealed to make it easy to detect cheating. The cars all use the same tires, springs, dampers, and adjustable anti-roll bars.

In September 2009, Moses Smith Racing, LLC. (MSR), headquartered at the time in Tempe, AZ, took over all support and manufacturing rights for the approximately 300 Formula Mazda rotary-powered race cars currently in use across North America, as well as the MSR sports racer, a full-bodied version of the FM. MSR has since moved to a new location at Motorsport Ranch (a country club style race track facility) in Cresson, TX. Moses Smith also owns and operates Texas Autosports, a full service Formula Mazda Racecar prep shop located at Motorsport Ranch in Cresson, TX. It is essentially the one-stop shop for Formula Mazda Racing. Moses Smith Racing, the manufacturer of the Formula Mazda, as well as Texas Autosports, both owned by Moses Smith are operating out of an 8000+ square foot facility at what is affectionately dubbed 'The Ranch'.

In 2004, a completely new car was introduced for the Pro series. It features a carbon fiber chassis, 6 speed sequential gearbox, and a sealed 250 hp fuel-injected Renesis engine very similar to the one in the Mazda RX-8. The MoTeC ECU uses input from the gearshift to enable upshifting while the driver holds the throttle wide open. The ECU also provides traction control which the driver can turn off from inside the car. The rules allow a choice among five different spring rates at each corner, and the new Öhlins dampers offer separate bump and rebound adjustments. The driver can adjust the front anti-roll bar from the cockpit.

The new car is substantially faster than the older car, usually lapping about 3 seconds faster per mile of track, but the original car remains legal for SCCA club racing.

Wikimedia Commons has media related to Formula Mazda.

• Formula Mazda Challenge presented by Goodyear
• Pro Mazda Championship official website
• Mazda Racers – The Mazda Racing Community
• Formula Mazda
• Texas Autosports