Wivenhoe Dam

The Wivenhoe Dam is a rock and earth-fill embankment dam with a concrete spillway across the Brisbane River in South East Queensland, Australia. The dam wall is located about 80 kilometres (50 mi) by road from the centre of Brisbane. The primary purpose of the dam is the supply of potable water for the Brisbane and Ipswich regions. In addition, the dam also provides for flood mitigation control, hydroelectricity and for recreation.[1] The impounded reservoir is called Lake Wivenhoe and the dam, the lake and a narrow strip of surrounding land forms a locality also called Lake Wivenhoe.

Wivenhoe Dam
The Wivenhoe Dam wall and spillway
Location of the Wivenhoe Dam in Queensland
CountryAustralia
LocationSouth East Queensland
Coordinates27°23′38″S 152°36′28″E
Purpose
StatusOperational
Construction beganMarch 1973 (1973-03)
Opening date1984 (1984)
Operator(s)SEQ Water
Dam and spillways
Type of damEmbankment dam
ImpoundsBrisbane River
Height59 m (194 ft)
Height (thalweg)23 m (75 ft) AHD
Length2,300 m (7,500 ft)
Elevation at crest79 m (259 ft) AHD
Dam volume4,140×10^3 m3 (146×10^6 cu ft)
Spillways2
Spillway type
Spillway capacity12,000 m3/s (420,000 cu ft/s)
Reservoir
CreatesWivenhoe Reservoir
Total capacity1,165,238 ML (256,317×10^6 imp gal; 307,823×10^6 US gal)
Catchment area7,020 km2 (2,710 sq mi)
Surface area109.4 km2 (42.2 sq mi)
Wivenhoe Power Station
Operator(s)Tarong Energy
Commission dateMay 1984
TypePumped-storage
Turbines2
Installed capacity500 MW (670,000 hp)
Website
www.seqwater.com.au

Wivenhoe Dam was planned in the early 1970s. The 1974 Brisbane flood highlighted the need for flood protection for South East Queensland.[2] The lake also forms part of the water storages for the Wivenhoe Power Station.

Location and features

The earth and rock dam structure is 59 metres (194 ft) high and 2,300 metres (7,500 ft) long. The 4,140-thousand-cubic-metre (146×10^6 cu ft) dam wall holds back the 1,165,000-megalitre (256×10^9 imp gal; 308×10^9 US gal) reservoir when at full capacity. From a catchment area of 7,020 square kilometres (2,710 sq mi) that includes much of the southwestern slopes of the D'Aguilar National Park, the dam creates Lake Wivenhoe, with a surface area of 1,094 hectares (2,700 acres), a maximum shoreline of 462 kilometres (287 mi), and an average annual evaporation level of 1,872 mm (73.7 in). The gated spillway, with five steel crest gates that are 12 metres (39 ft) wide and 16.6 metres (54 ft) high, has a discharge capacity of 12,000 cubic metres per second (420,000 cu ft/s).[1] The dam also has an auxiliary spillway to stop over-topping. The dam is managed by SEQ Water since July 2008 when most dam assets were transferred to the statutory authority, as part of a water security project in the South East Queensland region, known as the South East Queensland Water Grid.[3]

Construction

A view of Lake Wivenhoe

Wivenhoe was initially investigated for a dam site in the 1890s and again in 1933.[4] Further investigations into a dam began in the mid 1960s. In November 1971, Government approval was given to proceed with construction. Acquisition of lands of the submerged portion of the dam began in March 1973. In 1976, the Government gave approval to proceed with construction of the pumped storage hydro-electric scheme.[5] Total cost for the hydro-electric project was A$450 million. In March 1977, the first construction contract was awarded.[5] The dam was designed by the Queensland Water Resources Commission.[5]

In June 1983, the partially completed dam mitigated a potentially severe flood that may have caused damage equal to the 1893 Brisbane flood.[6] Construction work, carried out by Thiess Brothers, was complete by 1985.[7] To provide the 337.5 square kilometres (130.3 sq mi) of land required for the dam, 200 properties were acquired. The catchment area has an average annual rainfall of 940 millimetres (37 in). The dam holds twice as much water as Sydney Harbour and can hold about seven times more water than the Hinze Dam on the Gold Coast. Wivenhoe Dam contributes to the Gold Coast's water supply.

Purpose

The dam is used to mitigate floods and provide drinking water

The dam was designed as a response to the floods that damaged Brisbane in 1974.[2] Built in the late 1970s – early 1980s as a multifunction facility by a consortium of construction companies including Thiess Brothers, Wivenhoe Dam provides a safe water supply to the people of Brisbane and adjacent regions. Additionally, Wivenhoe Dam serves as the lower storage in a pumped-storage, hydro-electric generating facility, the Wivenhoe Power Station. The upper reservoir is formed by Splityard Creek Dam, of earth and rock construction, with a capacity of 28,700 megalitres (6,300,000×10^3 imp gal; 7,600,000×10^3 US gal). Under normal conditions the dam supplies water via pipeline to both Tarong Power Station and Tarong North Power Station, but during drought conditions only supplies water to Tarong North.

Flood mitigation

Auxiliary spillway, upstream side

During a flood the dam is designed to hold back 1.45 million megalitres (320,000×10^6 imp gal; 380,000×10^6 US gal) of additional water for flood mitigation or 225% capacity.[8] Under the water release plan which is defined by law, excess water must be released from the dam within seven days or a week of it reaching 100% capacity.[9] Between April 2004 and September 2008, a 165-metre (541 ft) wide auxiliary spillway with a three-bay fuse plug was installed on the western portion of the dam to further mitigate flooding.[10] In 2007, a feasibility study concluded that Wivenhoe Dam failed to satisfy the Australian National Committee on Large Dams (ANCOLD) guidelines on acceptable flood capacity.[11]

2000-2007 Drought

Brisbane water levels reduced to under 20% of capacity, having had no substantial inflow for five years.[12]

2011 Queensland floods

The largest ever recorded inflows for the dam occurred in January 2011.[13] On 11 January 2011, Wivenhoe Dam reached its highest level ever, 191% of normal water supply storage capacity, as it held back floodwater.[14] Because it is an embankment dam, it was not designed to spill over its crest or overtop and there is a risk that if waters spilled over the crest, this could erode the dam wall and potentially cause the dam to fail.[8] In this scenario the water level would need to rise to 225% capacity. To prevent this, the dam was designed and built to include a second emergency spillway.[8] During the peak of the flooding event the dam water level reached 60 centimetres (24 in) below the auxiliary spillway height.[11]

Recycled water

In 2006, emergency plans for placing fully treated recycled water from the Western Corridor Recycled Water Scheme into the dam to supplement supply were made public. Sixty million litres of recycled water were to be pumped into the dam by early 2009.[15] Increasing rainfall from 2008 resulted in the plan for recycled water to enter the region's drinking water supply to be postponed.

Recreation

Lake Wivenhoe is also a camping and outdoor recreation destination. Camping sites are provided at Captain Logan and Lumley Hill Areas.[16] The managed camping facilities at Captain Logan Camp include hot showers, barbecues and toilets, and are adjacent to playgrounds and a boat ramp at Logan Inlet. Cormorant Bay, Hamon Cove and Spillway Common also have facilities for picnic.[16]

A stocked impoundment permit is required to fish in the dam.[17] Swimming is permitted and camp sites have been established. Electric and non-powered boating with a permit is allowed, but domestic animals are banned.[18]

Fauna

The dam is home to the vulnerable Australian lungfish.[19] Anne Kemp, a researcher from the University of Queensland, estimates there was a population of 800 in 2010 but many are swept out of the dam when the spillway is opened[20][21] and that their food source of molluscs and clams is insufficient to maintain the lungfish in the dam.[22]

Self-sustaining populations of lungfish have lived in dams in South East Queensland for over 100 years since 1896. Lungfish were originally restricted to the Mary and Burnett river systems but due to perceived threats to their survival they were introduced to other rivers and dams, including the Brisbane River, in 1895–1896.[23] This was done to improve the viability of the species.

See also

References

  1. "Register of Large Dams in Australia" (Excel (requires download)). Dams information. Australian National Committee on Large Dams. 2010. Retrieved 5 July 2014.
  2. "Wivenhoe and Somerset Dams" (PDF). SEQ Water Grid. The Queensland Cabinet and Ministerial Directory. Retrieved 13 January 2011.
  3. Hurst, Daniel (7 July 2009). "Water funds slash debt". The Bayside Bulletin. Retrieved 21 April 2008.
  4. Queensland Environmental Protection Agency, Heritage Trails of the Great South East, State of Queensland, 2000 ISBN 0-7345-1008-X
  5. Dunn, Col (1985). The History of Electricity in Queensland. Bundaberg: Col Dunn. p. 171. ISBN 0-9589229-0-X.
  6. Cole, John R. (1984). Shaping a city. Albion, Queensland: William Brooks Queensland. p. 316. ISBN 0-85568-619-7.
  7. "Thiess Barnard JV to build Queensland dam". Construction Index. 1 December 2011. Retrieved 3 January 2020.
  8. Andersen, Brigid (11 January 2011). "Wivenhoe put to the ultimate test". ABC New. Australia. Retrieved 11 January 2011.
  9. Heger, Ursula; Caldwell, Anna (14 October 2010). "Parts of Brisbane set to flood as water released from Wivenhoe Dam combines with high tide". The Courier-Mail. Queensland. Retrieved 17 October 2010.
  10. "In-Congress Technical Tours". International Association for Hydro-Environment Engineering and Research. Retrieved 12 January 2011.
  11. Callinan, Rory (13 January 2011). "Engineers reduce dam flow". The Australian. Retrieved 14 January 2011.
  12. "Dam Levels".
  13. "BoM keeps mum on January forecast flaws". Brisbane Times. 8 March 2011. Retrieved 10 March 2011.
  14. "Controlled releases at Wivenhoe cut". Nine News. 12 January 2011. Retrieved 12 January 2011.
  15. Greg Roberts (9 November 2008). "Warning over recycled water". The Courier-Mail. Queensland Newspapers. Retrieved 21 September 2010.
  16. "Lakes – Somerset, Wivenhoe and Atkinson". Somerset Regional Council. Retrieved 21 September 2010.
  17. "Do I need a permit to go fishing in a dam?". Department of Agriculture, Fisheries and Forestry. Queensland Government. 5 February 2013. Retrieved 5 July 2014.
  18. "Lake Wivenhoe". ourbrisbane.com. Brisbane City Council. Retrieved 21 September 2010.
  19. "Australian Lungfish (Neoceratodus forsteri)". Department of Sustainability, Environment, Water, Population and Communities. 2003. Retrieved 14 January 2011.
  20. "Neoceratodus forsteri – Australian Lungfish, Queensland Lungfish". Department of Sustainability, Environment, Water, Population and Communities. Retrieved 14 January 2011.
  21. "Where lungfish are found". Anne Kemps Lungfish. Retrieved 14 January 2011.
  22. Tony Moore (28 October 2010). "Wivenhoe lungfish woes follow Traveston warnings". Brisbane Times. Fairfax Media. Retrieved 6 November 2010.
  23. "The unique Australian Lungfish". Queensland Museum. Retrieved 15 January 2011.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.