Kansas City standard

The SWTPC AC-30 Cassette Interface implemented the Kansas City standard. It sold for $80 in May 1976.

The Kansas City standard (KCS), or Byte standard, is a way of storing digital data on standard audio cassettes at data rates of 300 to 2400 bits per second (at 300–2400 baud) that was first defined in 1976. It was the default encoding used by several machine families, including those from Acorn and the MSX. It was also the standard used for cross-platform BASICODE distribution.

It originated in a symposium sponsored by Byte magazine in November 1975 in Kansas City, Missouri to develop a standard for storage of digital microcomputer data on inexpensive consumer quality cassettes. Although the standard existed from the earliest days of the microcomputer revolution, it failed to prevent a proliferation of alternative encodings.

History

Early cassettes

Early microcomputers generally used punched tape for program storage, an expensive option. Computer consultant Jerry Ogdin conceived the use of audio tones on a cassette to replace the paper tapes. He took the idea to Les Solomon, editor of Popular Electronics magazine, who was similarly frustrated by punched tapes. In September 1975 the two co-authored an article on the HITS (Hobbyists' Interchange Tape System), using two tones to represent 1s and 0s. Soon after a number of manufacturers started using similar approaches, although each of these systems were incompatible.[1]

Kansas City symposium

Wayne Green, who had just started Byte magazine, wanted all the manufacturers to get together and produce a single cassette standard. The site picked was Kansas City, Missouri. The two-day meeting on 7-8 November 1975[2] whose participants settled on a system based on Don Lancaster's design, published in Byte magazine's first issue.[3] After the meeting, Lee Felsenstein (Processor Technology) and Harold Mauch (Percom) wrote the standard.

A cassette interface is similar to a modem connected to a serial port. The 1s and 0s from the serial port are converted to audio tones using audio frequency-shift keying (AFSK). A '0' bit is represented as four cycles of a 1200 Hz sine wave, and a '1' bit as eight cycles of 2400 Hz. This gives a data rate of 300 baud. Each frame starts with one start bit (a '0') followed by eight data bits (least significant bit first) followed by two stop bits ('1's). So each frame is 11 bits, for a data rate of ​27 3⁄11 bytes per second.

The February 1976 issue of Byte had a report[4] on the symposium, and the March issue featured two hardware examples by Don Lancaster[5] and Harold Mauch.[6] The 300 baud rate was reliable but slow. (The typical 8-kilobyte BASIC program took five minutes to load.) Most audio cassette circuits would support higher speeds.

According to Solomon, the efforts were unsuccessful, "Unfortunately, it didn't last long; before the month ended, everyone went back to his own tape standard and the recording confusion got worse."[1]

The participants of the Kansas City symposium include the following.[4]

CUTS

Processor Technology developed the popular CUTS (Computer Users' Tape Standard) which works at either 300 or 1200 baud. They provided the S-100 bus CUTS Tape I/O interface board which offers both CUTS and Kansas City standard support to any S-100 system.

Tarbell

The Tarbell Cassette Interface, which, according to early PC retailer Stan Veit, "became a de facto standard for S-100 computers", supported, in addition to the Tarbell "native" mode ("Tarbell standard"), also supported the Kansas City Standard[7].

Floppy ROM

Interface Age magazine May 1977 issue, with a Kansas City standard flexi disc floppy ROM

In August 1976 at the Personal Computing show in Atlantic City, Bob Marsh of Processor Technology approached Bob Jones, the publisher of Interface Age magazine, about pressing software onto vinyl records. Processor Technology provided an 8080 program to be recorded. This test record did not work and Processor Technology was unable to devote more time to the effort.[8]

Daniel Meyer and Gary Kay of Southwest Technical Products arranged for Robert Uiterwyk to provide his 4K BASIC interpreter program for the 6800 microprocessor. The idea was to record the program on audio tape in the "Kansas City" standard format and then make a master record from the tape. Eva-Tone made Soundsheets on thin vinyl that would hold one song.[9] These were inexpensive and could be bound in a magazine.

Bill Turner[10] and Bill Blomgren[11] of MicroComputerSystems Inc. along with Bob Jones[8] of Interface Age and Bud Schamburger of Holiday Inn worked with EVA-TONE and developed a successful process. The intermediate stage of recording to tape produced dropouts so a SWTPC AC-30[12] cassette interface was connected directly to the record cutting equipment.

The May 1977 issue of Interface Age contains the first "Floppy ROM", a 33​1⁄3 RPM record containing about six minutes of Kansas City standard audio. The September 1978 Floppy ROM Number 5 has two sides: Apple BASIC "the automated dress pattern" and IAPS format "A program for writing letters".

300 baud

The original standard recorded data as "marks" (one) and "spaces" (zero). A mark bit consisted of eight cycles at a frequency of 2400 Hz, while a space bit consisted of four cycles at a frequency of 1200 Hz. A word, usually one byte (8 bits) long, was recorded in little endian order, i.e. least significant bit first. 7-bit words were followed by a parity bit.

1200 baud

Acorn Computers Ltd implemented a 1200 baud variation of CUTS in their BBC Micro[13] and Acorn Electron microcomputers, which reduced a '0' bit to one cycle of a 1200 Hz sine wave and a '1' bit to two cycles of a 2400 Hz wave. Standard encoding includes a '0' start bit and '1' stop bit around every 8 bit piece of information, giving an effective data rate of 960 bits per second.

Also, these machines record data in 256-byte blocks interspersed with gaps of carrier tone, each block carrying a sequence number and a CRC checksum, so that it is possible to rewind the tape and retry from the failed block when a read error occurs.

2400 baud

The MSX by default supports both a 1200 baud variation of the standard with the same bit encoding as Acorn's, and a 2400 baud variant which doubles the audio rate — a '0' bit is one cycle of a 2400 Hz wave and a '1' bit is two cycles of a 4800 Hz wave[14]. Unlike Acorn machines, the MSX uses two '1' stop bits in addition to one '0' start bit, so the effective rate at 1200 baud is approximately 873 bits per second, and the effective rate at 2400 baud is approximately 1,745 bits per second.

The machine's BIOS can read data at up to 3600 baud from an ideal audio source.

Computers using the Kansas City standard

Early microcomputers

(several use S-100 bus)

  • Compukit UK101
  • Exidy Sorcerer Optional S-100 expansion bus, standard 300 bit/s mode and a 1200 baud variant by default.
  • Kim-1, MOS Technology Optional S-100 expansion bus (KIMSI), standard 300 bit/s mode and a hypertype 1200 baud variant.
  • Lucas Nascom 1, 2 (which also supported a 1200 bit/s variant, see below)
  • MITS Altair 8800
  • Motorola MEK D1 6800 board
  • Ohio Scientific C1P/ Superboard II
  • Processor Tech SOL-20 Terminal Computer
  • Processor Tech CUTS S-100 bus Tape I/O interface board
  • SWTPC's 6800-based computers
  • Tangerine MICROTAN 65 (300 baud CUTS - faster 2400 non-CUTS format also available)
  • Eltec (German Company) Eurocom 1
  • Z80 Starter Kit (1977 - Development board by SD Systems - 300 bauds - S-100 bus)

Home and personal computers

Programmable calculators

Other devices

See also

Further reading

  • Feichtinger, Herwig (1987). "1.8.3. Kassettenaufzeichnung" [1.8.3. Cassette recording]. Arbeitsbuch Mikrocomputer [Microcomputer work book] (in German) (2 ed.). Munich, Germany: Franzis-Verlag GmbH. pp. 230–235. ISBN 3-7723-8022-0.
  • Hübler, Bernd (1987) [1986]. "2.6. Kassetteninterface" [2.6. Cassette interface]. In Erlekampf, Rainer; Mönk, Hans-Joachim. Mikroelektronik in der Amateurpraxis [Micro-electronics for the practical amateur] (in German) (3 ed.). Berlin: Militärverlag der Deutschen Demokratischen Republik, Leipzig. pp. 92–99, 164–165. ISBN 3-327-00357-2. 7469332.
  • von Cube, Marcus (2015-03-15). "CASsette IO Utilities". Archived from the original on 2017-03-14. Retrieved 2017-03-14.

References

  1. 1 2 Les Solomon, "Solomon's Memory", Digital Deli, 1984
  2. ↑ Bunnell, David (December 1975). "BYTE Sponsors ACR Standards Meeting". Computer Notes. Altair Users Group, MITS Inc. 1 (6): 1. Archived from the original on 2012-03-23. Retrieved 2007-05-04.
  3. ↑ Lancaster, Don (September 1975). "Serial Interface". BYTE. Vol. 0 no. 1. Green Publishing. p. 22. Retrieved 2018-04-10.
  4. 1 2 Manfred and Virginia Peschke (February 1976). "Report: BYTE's Audio Cassette Standards Symposium". BYTE. Vol. 0 no. 6. BYTE Publications. pp. 72–73.
  5. ↑ Don Lancaster (March 1976). "Build the Bit Boffer". BYTE. Vol. 0 no. 7. BYTE Publications. pp. 30–39.
  6. ↑ Harold A. Mauch (March 1976). "Digital Data on Cassette Recorders". BYTE. Vol. 0 no. 7. BYTE Publications. pp. 40–45.
  7. ↑ "The IMSAI 8800". pc-history.org. Retrieved 2018-09-24.
  8. ↑ Jones, Robert S. (May 1977). "The Floppy ROM Experiment". Interface Age. McPheters, Wolfe & Jones. 2 (6): .pp 28, 83.
  9. ↑ Penchansky, Alan (November 10, 1979). "New Building for 'Soundsheets' Firm". Billboard. Vol. 91 no. 45. New York: Billboard Publications. p. 88. ISSN 0006-2510.
  10. ↑ Turner, William W. (May 1977). "Robert Uiterwyk's 4K BASIC". Interface Age. McPheters, Wolfe & Jones. 2 (6): .pp 40–54.
  11. ↑ Blomgren, William (May 1977). "Platter BASIC: The Search for a Good, Random Access, Record Cutting Juke Box". Interface Age. McPheters, Wolfe & Jones. 2 (6): 29–36.
  12. ↑ Gary Kay (December 1976). "The Designer's Eye View of the AC-30". BYTE. Vol. 1 no. 16. BYTE Publications. pp. 98–108.
  13. ↑ R. T. Russell, BBC Engineering Designs Department (1981). The BBC Microcomputer System. PART II - HARDWARE SPECIFICATION (Report). The British Broadcasting Corporation. A cassette modem will be incorporated to allow storage of programs and data on a standard audio cassette recorder ... The format will be ... 300 baud and 1200 baud. ... It must be possible to switch between low-speed (CUTS) mode and high-speed mode
  14. ↑ "4, ROM BIOS". The MSX Red Book. Kuma Computers. 1985. ISBN 0-7457-0178-7. The MSX ROM uses a software driven FSK ... method for storing information on the cassette. At the 1200 baud rate this is identical to the Kansas City Standard ... At 1200 baud each 0 bit is written as one complete 1200 Hz LO cycle and each 1 bit as two complete 2400 Hz HI cycles ... When the 2400 baud rate is selected the two frequencies change to 2400 Hz and 4800 Hz but the format is otherwise unchanged.
  15. ↑ Acorn System 1 Technical Manual, p.15: "On the keyboard is a Computer Users Tape Standard interface"
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.