GMD GF6C

The GF6C was an electric locomotive for freight duties built by General Motors Diesel in collaboration with ASEA of Sweden.

EMD GF6C
EMD GF6C locomotive #6001 at the Railway & Forestry Museum in Prince George, BC.
Type and origin
Power typeElectric
BuilderGeneral Motors Diesel
Serial numberA4340–A4346
ModelGF6C
Build date1983–1984
Total produced7
Specifications
Configuration:
  AARC-C
  UICCo′Co′
Gauge4 ft 8 12 in (1,435 mm)
TrucksEMD HTC
Wheel diameter42 in (1,067 mm)
Length68 ft 10 in (20.98 m)
Loco weight396,000 lb (180,000 kilograms)
Electric system/s50 kV AC Catenary
Current pickup(s)Pantograph
Traction motors6 × EMD E88X
Performance figures
Power output6,000 hp (4.47 MW)
Career
OperatorsBC Rail (BCOL)
NumbersBCOL 6001–6007
LocaleBritish Columbia, Canada
Disposition6 scrapped, 1 preserved

Seven of these locomotives were built in 1983 and 1984, for use on the BC Rail's electrified Tumbler Ridge subdivision.

Similar to EMD's GM6C testbed locomotive, the GF6C used a frame and running gear that was identical to that of EMD's popular SD40-2 diesel-electric locomotive,[1] but had a wide cab and carbody similar to that of GMD's SD40-2F.

BC Rail chose electrification for the Tumbler Subdivision because of the long, non-ventilated tunnels, as well as steep grades and sharp curves. The line served the Quintette and Bull-Moose coal mines, and hauled coal from said mines to an interchange with CN, where diesel power took over to haul the coal to Prince Rupert where it was loaded onto deep-sea coal carrier ships.

A combination of the declining coal market, and lack of coal being produced from the Quintette mine led to the electric system being shut down due to low traffic, and high maintenance costs. The system transferred over to diesel hauled trains after the last electrically hauled train left the Teck loadout (Bull-moose mine) on October 1, 2000. Towards the later years of operation, the GF6C units were de-rated due to the high amount of traction motor failures during operation. It is not known what their horsepower rating was after this modification, however loaded trains leaving the east side of the subdivision typically saw the use of 3 leading units, and 3 helper units per train. Previously, each loaded train would typically have 2 leading units, and 2 helper units. The helper units would be cut from the train upon reaching the summit.[2]

In 2004, the Paul D. Roy family purchased locomotive 6001 and donated it to the Prince George Railway and Forestry Museum in Prince George; the remaining six locomotives were scrapped. 6001 is currently preserved and in remarkable condition, and, according to the museum's curator and park manager, is still operable if provided with 50 kV of electricity.

References

  1. Marre, Louis A, & Pinkepank, Jerry A. (1989). The Contemporary Diesel Spotter's Guide. Kalmbach Publishing Co., Milwaukee, WI. ISBN 0-89024-088-4.
  2. Dale Sanders (December 2000). An Electrified Finale. CTC Board. p. 29.

See also

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.