Tonne

Tonne
One tonne is equal to 1000 kilograms or 1 megagram
Unit information
Unit system Non-SI unit accepted for use with SI
Unit of Mass
Symbol t
In SI base units: 1 t = 1000 kg (1 Mg)

The tonne (/tʌn/ ( listen)) (Non-SI unit, symbol: t), commonly referred to as the metric ton in the United States, is a non-SI metric unit of mass equal to 1,000 kilograms;[1][2][3][4] or one megagram (Mg); it is equivalent to approximately 2,204.6 pounds,[5] 1.102 short tons (US) or 0.984 long tons (UK). Although not part of the SI, the tonne is accepted for use with SI units and prefixes by the International Committee for Weights and Measures.[6]

The metric tonne is derived from the weight of pure water; there are 1,000 litres in one metric tonne.

Symbol and abbreviations

The SI symbol for the tonne is "t", adopted at the same time as the unit in 1879.[2] Its use is also official for the metric ton in the United States, having been adopted by the United States National Institute of Standards and Technology.[7] It is a symbol, not an abbreviation, and should not be followed by a period. Informal and non-approved symbols or abbreviations include "T", "mT", "MT", and "mt".[8] Some of these are SI symbols for other units: "T" is the SI symbol for the tesla and "Mt" is the SI symbol for megatonne (equivalent to one teragram); if describing TNT equivalent units of energy, this is equivalent to 4.184 petajoules.

Origin and spelling

In French and all English-speaking countries that are predominantly metric, tonne is the correct spelling. It is usually pronounced the same as ton /tʌn/, but when it is important to clarify that the metric term is meant, rather than short ton, the final "e" can also be pronounced, i.e. "tonny" /ˈtʌnɪ/.[9] In Australia, it is also pronounced /tɒn/.[10]

Before metrication in the UK the unit used for most purposes was the Imperial ton of 2,240 pounds avoirdupois or 20 hundredweight (usually referred to as the long ton in the US), equivalent to 1,016 kg, differing by just 1.6% from the tonne. The UK Weights and Measures Act 1985 explicitly excluded from use for trade certain imperial units, including the ton, unless the item being sold or the weighing equipment being used was weighed or certified prior to 1 December 1980, and even then only if the buyer was made aware that the weight of the item was measured in imperial units.[11][12][13]

In the United States metric ton is the name for this unit used and recommended by NIST;[7] an unqualified mention of a ton almost invariably refers to a short ton of 2,000 pounds (907 kg), and tonne is rarely used in speech or writing.

Ton and tonne are both derived from a Germanic word in general use in the North Sea area since the Middle Ages (cf. Old English and Old Frisian tunne, Old High German and Medieval Latin tunna, German and French tonne) to designate a large cask, or tun.[14] A full tun, standing about a metre high, could easily weigh a tonne. An English tun (an old wine cask volume measurement equivalent to 954 litres) of wine weighs roughly a tonne, 954 kg if full of water, a little less for wine.

The spelling tonne pre-dates the introduction of the SI in 1960; it has been used with this meaning in France since 1842,[15] when there were no metric prefixes for multiples of 106 and above, and is now used as the standard spelling for the metric mass measurement in most English-speaking countries.[16][17][18][19] In the United States, the unit was originally referred to using the French words millier or tonneau,[20] but these terms are now obsolete.[3] The Imperial and US customary units comparable to the tonne are both spelled ton in English, though they differ in mass.

Conversions

One tonne is equivalent to:

  • Metric/SI: 1 megagram (Mg) (by definition). Equal to 1000000 grams (g) or 1000 kilograms (kg).
    • Megagram, Mg, is the official SI unit. Mg is distinct from mg, milligram.
  • Pounds (lb): Exactly 1000/0.45359237 lb (by definition of the pound),[21] or approximately 2204.622622 lb (10 s.f.).
  • US/Short tons (ST): Exactly 1/0.90718474 short tons, or approximately 1.102311311 ST (10 s.f.).
    • One short ton is exactly 0.90718474 t.[22]
  • Imperial/Long tons (LT): Exactly 1/1.0160469088 long tons, or approximately 0.9842065276 LT (10 s.f.).
    • One long ton is exactly 1.0160469088 t.[22]

Derived units

For multiples of the tonne, it is more usual to speak of thousands or millions of tonnes. Kilotonne, megatonne, and gigatonne are more usually used for the energy of nuclear explosions and other events in equivalent mass of TNT, often loosely as approximate figures. When used in this context, there is little need to distinguish between metric and other tons, and the unit is spelt either as ton or tonne with the relevant prefix attached.[23]

Tonnes Grams Equivalents*
MultipleNameSymbol MultipleNameSymbol Tonnes (t)Kilograms (kg)Grams (g)US/short tons (ST)Imperial/long tons (LT)
100Tonnet 106MegagramMg 1 t1,000 kg1 million g1.1023 ST0.98421 LT
103Kilotonnektǂ 109GigagramGg 1,000 t1 million kg1 billion g1,102.3 ST984.21 LT
106MegatonneMt 1012TeragramTg 1 million t1 billion kg1 trillion g1.1023 million ST984,210 LT
109GigatonneGt 1015PetagramPg 1 billion t1 trillion kg1 quadrillion g1.1023 billion ST984.21 million LT
1012TeratonneTt 1018ExagramEg 1 trillion t1 quadrillion kg1 quintillion g1.1023 trillion ST984.21 billion LT
1015PetatonnePt 1021ZettagramZg 1 quadrillion t1 quintillion kg1 sextillion g1.1023 quadrillion ST984.21 trillion LT
1018ExatonneEt 1024YottagramYg 1 quintillion t1 sextillion kg1 septillion g1.1023 quintillion ST984.21 quadrillion LT

*The equivalent units columns use the short scale large-number naming system currently used in most English-language countries, e.g. 1 billion = 1,000 million = 1,000,000,000.

Values in the equivalent short and long tons columns are rounded to five significant figures, see Conversions for exact values.

ǂThough non-standard, the symbol "kt" is also used for knot, a unit of speed for aircraft and sea-going vessels, and should not be confused with kilotonne.

Alternative usage

A metric ton unit (mtu) can mean 10 kilograms (22 lb) within metal (e.g. tungsten, manganese) trading, particularly within the US. It traditionally referred to a metric ton of ore containing 1% (i.e. 10 kg) of metal.[24][25] The following excerpt from a mining geology textbook describes its usage in the particular case of tungsten:

"Tungsten concentrates are usually traded in metric tonne units (originally designating one tonne of ore containing 1% of WO3, today used to measure WO3 quantities in 10 kg units. One metric tonne unit (mtu) of tungsten (VI) contains 7.93 kilograms of tungsten." (Walter L Pohl, Economic Geology: Principles and Practices, English edition, 2011, p 183.)

Note that tungsten is also known as wolfram and has the atomic symbol W.

In the case of uranium, the acronym MTU is sometimes considered to be metric ton of uranium, meaning 1,000 kg.[26][27][28][29]

A gigatonne of carbon dioxide equivalent (GtCO2eq) is a unit used by the UN climate change panel, IPCC, to measure the effect of a technology or process on global warming.

Use of mass as proxy for energy

The tonne of trinitrotoluene (TNT) is used as a proxy for energy, usually of explosions (TNT is a common high explosive). Prefixes are used: kiloton(ne), megaton(ne), gigaton(ne), especially for expressing nuclear weapon yield, based on a specific combustion energy of TNT of about 4.2 MJ/kg (or one thermochemical calorie per milligram). Hence, 1 t TNT = 4.2 GJ, 1 kt TNT = 4.2 TJ, 1 Mt TNT = 4.2 PJ.

The SI unit of energy is the joule. Assuming that a TNT explosion releases 1,000 small (thermochemical) calories per gram (4.2 kJ/g), one tonne of TNT is equivalent to 4.2 gigajoules.

In the petroleum industry the tonne of oil equivalent (toe) is a unit of energy: the amount of energy released by burning one tonne of crude oil, approximately 42 GJ. There are several slightly different definitions. This is ten times as much as a tonne of TNT because atmospheric oxygen is used.

Unit of force

Like the gram and the kilogram, the tonne gave rise to a (now obsolete) force unit of the same name, the tonne-force, equivalent to about 9.8 kilonewtons: a unit also often called simply "tonne" or "metric ton" without identifying it as a unit of force. In contrast to the tonne as a mass unit, the tonne-force or metric ton-force is not acceptable for use with SI, partly because it is not an exact multiple of the SI unit of force, the newton.

See also

Notes and references

  1. Weights and Measures Act 1985. National Archives (London), 2014. Accessed 13 Aug 2014.
  2. 1 2 Table 6 Archived 2009-10-01 at the Wayback Machine.. BIPM. Retrieved on 2011-07-10.
  3. 1 2 "Metric System of Measurement: Interpretation of the International System of Units for the United States" (PDF). Federal Register. 63 (144): 40338. July 28, 1998. 63 FR 40333. Archived from the original (PDF) on October 15, 2011.
  4. The International System of Units (SI) (PDF), 8th Edition, 2006, Section 4.1
  5. United States National Bureau of Standards (1959-06-25). "Notices "Refinement of values for the yard and the pound"" (PDF). Retrieved 2006-08-12.
  6. Corey, Pamela L (1 February 2016). "NIST Guide to the SI, Appendix B.8: Factors for Units Listed Alphabetically".
  7. 1 2 Metric System of Measurement: Interpretation of the International System of Units for the United States (PDF). See corrections in the Errata section of .
  8. "Metric ton (MT)". BusinessDictionary.com. WebFinance, Inc. 2015. Retrieved October 25, 2015.
  9. The Oxford English dictionary 2nd ed. lists both /tʌn/ and /ˈtʌnɪ/
  10. Macquarie Dictionary (fifth ed.). Sydney: Macquarie Dictionary Publishers Pty Ltd. 2009.
  11. A Dictionary of Weights, Measures, and Units, edited by Donald Fenna, Oxford University Press
  12. "Weights and Measures Act 1985". Section 8(1), Act No. 72 of 30 October 1985. Retrieved 11 Apr 2016.
  13. "Weights and Measures Act 1985". Schedule 11(13 - 14), Act No. 72 of 30 October 1985. Retrieved 11 Apr 2016.
  14. Harper, Douglas. "tonne". Online Etymology Dictionary.
  15. "Recherche d'un mot". atilf.atilf.fr.
  16. "Guidance Note on the use of Metric Units of Measurement by the Public Sector" (PDF). National Measurement Office. 2007. Archived from the original (PDF) on 2011-02-07. Retrieved 2010-02-13. "Tonne" is listed under "The Principal Metric Units of Measurement" on p. 7.
  17. "National Measurement Regulations 1999 |". Australian Government. 1999. Retrieved 2010-02-13. "Tonne" is listed under Schedule 1, Part 3 as a non-SI unit of measurement used with SI units of measurement.
  18. "Appendix 4: Units of Measurement and Conversion Factors". MAF (Ministry of Agriculture and Forestry (New Zealand)). Retrieved 2010-02-13.
  19. "Canada Gazette". Government of Canada. 1998–2007. Retrieved 2010-02-13. The Corporation shall pay to producers selling and delivering wheat produced in the designated area to the Corporation the following sums certain per tonne basis...
  20. Act of July 28, 1866, codified in 15 U.S.C. § 205
  21. Barbrow, L.E.; Judson, L.V. (1976). Weights and measures standards of the United States – A brief history. Archived from the original on 2008-05-11.
  22. 1 2 National Institute of Standards and Technology. Butcher, Tina; Crown, Linda; Harshman, Rick; Williams, Juana, eds. (October 2013). "Appendix C – General Tables of Units of Measurement" (PDF). Specifications, Tolerances, and Other Technical Requirements for Weighing and Measuring Devices. NIST Handbook. 44 (2014 ed.). Washington, D.C.: U.S. Department of Commerce, Technology Administration, National Institute of Standards and Technology. p. C-13. ISSN 0271-4027. OCLC 58927093. Retrieved 10 December 2013.
  23. The Oxford English Dictionary 2nd ed. gives both megaton and megatonne and adds "The unit may be calculated in either imperial or metric tons; the form megatonne generally implies the metric unit". The use for energy is the first definition; use for mass or weight is the third definition.
  24. "Platt's Metals Guide to Specifications - Conversion Tables". 8 September 2008. Archived from the original on 8 September 2008.
  25. How Many? A Dictionary of Units of Measurement. Unc.edu. Retrieved on 2011-07-10.
  26. Reference.Pdf. (PDF) . Retrieved on 2011-07-10.
  27. "Glossary". (June 2000). Disposition of Surplus Hanford Site Uranium, Hanford Site, Richland, Washington. US Department of Energy.
  28. "Acronyms". Y-12 National Security Complex.
  29. NRC Collection of Abbreviations (NUREG-0544, Rev. 4), United States Nuclear Regulatory Commission. Nrc.gov (2011-03-13). Retrieved on 2011-07-10.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.