Chinese button knot
| Chinese button knot | |
|---|---|
 Doubled Chinese button knot, flat and tightened in the same picture | |
| Category | Decorative |
| Category 2 | Stopper |
| Related | diamond knot, Celtic button knot |
| Typical use | clothing button |
| ABoK | #599 |
Chinese button knot is essentially a diamond knot where the lanyard loop is shortened to a minimum, i.e. tightened to the knot itself. There emerges therefore only two lines next to each other from the knot: the beginning and the end. The knot has traditionally been used as a button on clothes in Asia, thus the name.
The Chinese Button Knot is worn throughout China on underwear and night clothes. Buttons of this sort are more comfortable to lie on and to rest against than common bone and composition buttons, and they cannot be broken even by the laundry.
A Chinese tailor ties the knot without guide, flat on his table. But one may be more quickly and easily tied in hand by a modification of the sailor’s method of tying his knife lanyard knot (#787). The two knots are tied alike, but they are worked differently.
Tying
The diamond knot is usually tied with a carrick bend as a first step. This results then in a knife lanyard knot which can be used as a button hole, as well as a button.
Tying starts with a diagonal carrick bend
Ends continue around and under the standing part on the other side
Ends up through the middle hole
Tightened
There is however a tying method that does not require a carrick bend as a first step, and does not produce a lanyard loop that needs to be reduced when used as a button. This method provides just the button, a spherical basket weave knot, in the style of Turk's head knot or diamond knot.
Instructions for tying Chinese button knot in single configuration using this method as illustrated in the adjacent image, with four steps in tying it; thin red lines showing the move(s) to get to the next step:
- Under hand slip knot, with slip-end exiting upwards to the right.
- Slip-end leftwards over the knot, under and up through the slip loop, resulting in two interlocking slip knots in radial symmetry, with ends exiting upwards.
- Ends down the opposite triangular holes at center, while swirling slightly around each other resulting in a four petaled flower with double stem,
- For a several strand Chinese button knot one end follows consistently along the in- or out- side of the other stem back to the same point after having traversed all four petals.
- Tightened to an evenly spherical button.
To tie the button: Take a piece of banding about three feet long, middle it, and lay it across the left hand as pictured. Take the end from the back of the hand and make a right turn around the tip of the left thumb. Bend the left thumb and hold the turn against the standing part of the cord. Take the left end and tuck it to the right, under the first end and then to the left under the upper center part of the knot. The knot should now have a regular over-one-and under-one sequence throughout.
Still keeping the knot in hand, tuck both ends under the rim and up through the center compartment of the knot as pictured in the
third diagram.
Remove the knot from the hand, turn it completely over, and allow the two ends to hang down between the two middle fingers of the left hand as drawn in the fifth diagram. Work out the surplus material of the loop without distorting the knot and arrange it...— The Ashley Book of Knots[1]
See also
- Tangzhuang, a jacket which often incorporates knotted buttons
References
