Thiocarbanilide

Thiocarbanilide
Names
Preferred IUPAC name
N,N'-Diphenylthiourea
Other names
1,3-Diphenylthiourea
sym-Diphenylthiourea
Diphenylthiourea
1,3-Diphenyl-2-thiourea
DPTU
Sulfocarbanilide
Identifiers
3D model (JSmol)
ChEMBL
ChemSpider
ECHA InfoCard 100.002.732
UNII
Properties
C13H12N2S
Molar mass 228.312 g/mol
Appearance White powder
Density 1.32 g/cm3
Melting point 154.5 °C (310.1 °F; 427.6 K)
Boiling point decomposes
slightly soluble in water
Solubility very soluble in ethanol, diethyl ether, chloroform[1]
Hazards
NFPA 704
Flammability code 1: Must be pre-heated before ignition can occur. Flash point over 93 °C (200 °F). E.g., canola oilHealth code 2: Intense or continued but not chronic exposure could cause temporary incapacitation or possible residual injury. E.g., chloroformReactivity code 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g., liquid nitrogenSpecial hazards (white): no codeNFPA 704 four-colored diamond
1
2
0
Flash point 164.7 °C (328.5 °F; 437.8 K)
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☑Y verify (what is ☑Y☒N ?)
Infobox references

Thiocarbanilide is an organic chemical compound with the formula (C6H5NH)2CS. This white solid is a derivative of thiourea. It is prepared by the reaction of aniline and carbon disulfide.

Uses

Thiocarbanilide is commonly used as a vulcanization accelerator for rubber,[2] and as a stabilizer for PVC and PVDC. Its use as a vulcanization accelerator was discovered by BF Goodrich chemist George Oenslager.[3]

Reactions

Thiocarbanilide reacts with phosphorus pentachloride or hydrochloric acid, dilute sulfuric acid, acetic anhydride or iodine to produce phenyl isothiocyanate.

Toxicology

Oral, rat: LD50 = 50 mg/kg.

References

  1. ↑ Lide, David R. (1998), Handbook of Chemistry and Physics (87 ed.), Boca Raton, Florida: CRC Press, pp. 3–242, ISBN 0-8493-0594-2
  2. ↑ Hans-Wilhelm Engels, Herrmann-Josef Weidenhaupt, Manfred Pieroth, Werner Hofmann, Karl-Hans Menting, Thomas Mergenhagen, Ralf Schmoll, Stefan Uhrlandt "Rubber, 4. Chemicals and Additives" in Ullmann's Encyclopedia of Industrial Chemistry 2004, Wiley-VCH, Weinheim. doi:10.1002/14356007.a23_365.pub2
  3. ↑ Trumbull, H. L. (1933). "Accomplishments of the Medalist". Ind. Eng. Chem. 25 (2): 230–232. doi:10.1021/ie50278a030.


This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.