MagSafe

MagSafe Connector
MagSafe 1 connector attached to MacBook Pro
Type Computer power connector
Production history
Manufacturer Apple Inc.
Produced 2006
Superseded Apple Power Connector
Superseded by USB-C
General specifications
Hot pluggable Yes
External Yes
Pins 5
Pin out
Male connector, front view
Pin 1 GND (0 V)
Pin 2 V+ (14.5 / 16.5 / 18.5 / 20 V DC)
Pin 3 Charge control pin
Pin 4 V+ (14.5 / 16.5 / 18.5 / 20 V DC)
Pin 5 GND (0 V)
Gray area indicates magnetic connector shroud

MagSafe is a series of proprietary magnetically attached power connectors, originally introduced by Apple Inc. on January 10, 2006, in conjunction with the MacBook Pro at the Macworld Expo in San Francisco, California. The connector is held in place magnetically so that if it is tugged — for example, by someone tripping over the cord — it will pull out of the socket without damaging the connector or the computer power socket, and without pulling the computer off the surface on which it is located.[1]

History

The basic concept of MagSafe is copied from the magnetic power connectors that are part of many deep fryers and Japanese countertop cooking appliances since the early 2000s in order to avoid spilling their dangerously hot contents.[2][3][4] Apple was granted US Patent No. 7311526 on MagSafe ("Magnetic connector for electronic device", issued in 2007) as MagSafe was deemed to be a sufficient improvement due to the connector being symmetrical and reversible, and the fact that magnets within a connector are arranged in opposing polarities for improved coupling strength.

Apple has been phasing out the MagSafe connector; the relaunched MacBook and fourth-generation MacBook Pro replaced it with USB-C ports used for charging and data sync.[5][6] As of October 2018, the MacBook Air is the only remaining devices to use the MagSafe connector.[7]

Features

MagSafe has connector pins that are designed so the rectangular connector can be inserted in either orientation (however, the L-shaped version of the connector can only be fitted in one orientation without blocking neighboring ports, such as USB). LEDs on both the top and bottom of the connector show green if the computer battery is fully charged and amber or red if the battery is charging. MagSafe can be found on the MacBook, MacBook Pro and MacBook Air notebook computers, as well as the Apple LED Cinema Display.[8]

The MacBook and the 13-inch MacBook Pro use a 60 W MagSafe charger, whereas the 15- and 17-inch MacBook Pro use an 85 W MagSafe charger. The MacBook Air has a lower-powered 45 W version of the MagSafe adapter. The power brick is smaller, but the MagSafe connector is the same as on the 60 W and 85 W chargers. According to Apple, an adapter with the same or higher wattage than originally provided may be used without problems.[9]

Apple formerly offered a “MagSafe Airline Adapter” for use on certain compatible airplanes. It had a DC input (instead of AC like the original MagSafe chargers) and would power the computer, but would not charge the battery.[10]

Some Apple desktop displays included a MagSafe connector cable which allowed charging of Apple laptops.

MagSafe 2

MagSafe 2 was introduced on the MacBook Air and MacBook Pro with Retina Display at the 2012 Worldwide Developers Conference on July 11, 2012. It is incompatible with the older MagSafe connectors without an adapter, and returns to the T-shaped design that points straight out, rather than the L-shape that runs along the side of the machine. The connector was made thinner and wider to fit the thinner laptops.[11]

Pinout

The MagSafe connector pins allow for the adapter to be inserted in either of two orientations. The first and second pins on each side of the tiny central pin have continuity with their mirror pins.

  • The inner large pins are V+ (14.5 / 16.5 / 18.5 / 20 V DC). Measuring with no load will give 6.86 V DC for MagSafe and about 3 V DC for MagSafe 2; the full voltage is provided after a ~40 kOhm load is applied for one second.[12]
  • The outer large pins are ground.
  • The tiny center pin is a data pin using the 1-Wire protocol. The computer uses this pin to change the LED’s color and retrieve the serial number and wattage of the power supply.[12]
  • Only two wires – power and ground – go to the charger unit. There is no data communication via the adapter sense pin with the charger unit itself.[12]
  • The maximum voltage supplied is as follows:
    • 14.5 V DC for the 45 W units supplied with MacBook Air
    • 16.5 V DC for the 60 W units supplied with MacBook and 13" MacBook Pro
    • 18.5 V DC for the 85 W units supplied with 15" and 17" MacBook Pro
    • 20 V DC for the 85 W units supplied with 15" MacBook Pro Retina

The rectangular metal shroud surrounding the pins acts as shielding for the electrical pins and a ferrous attractor for the magnet in the laptop.

Third-party products

Although Apple does not license the MagSafe connector for use in third-party products, manufacturers have devised a workaround: their MagSafe items use the actual connector from Apple's AC adapter, grafted onto their own product. Since this uses an actual Apple product, purchased legally, manufacturers believe that no licensing agreements are needed (a principle referred to as the first sale doctrine) and the patents are not violated.[13] However, in 2010 Apple still sued one such manufacturer, Sanho Corporation for selling its very popular HyperMac battery extension products which Apple claimed violated their patents.[14] Sanho has since ceased to sell their connector cable for the HyperMac series of external batteries.[15]

Defects

Many users have reported (as of 30 October 2011) problems with the quality of the construction of the MagSafe cords, giving the product low marks on the Apple Store's website.[16] Common complaints include plug separating from the cord, transformer shorting, and pin springs losing elasticity.[16]

Several methods have been devised to protect the MagSafe from failure, including wrapping the cable with tape or sliding protective plastic around the cable.[17]

In 2008, Apple posted an official response acknowledging problems with MagSafe adapters, which include incomplete circuit connection and adapter's white insulation separating from the magnetic end of the MagSafe connector.[18] Following the release of a Knowledge Base article, a class-action lawsuit was filed on May 1, 2009, in the US District Court for the Northern District of California's San Jose office, alleging that the MagSafe power adapter is prone to frayed wires and overheating, and as such represents a fire hazard.[19]

Apple released a firmware update in October 2010 that it claims resolves this issue.[20] However, the installer for the firmware update will not run on certain older MacBooks, which means that the firmware can not be updated. This, in turn, means that it is not possible to use the new MagSafe power adapter with these MacBooks. However, as of 2017, Apple still sells the older MagSafe power adapter.[21]

In 2011, Apple posted a support document about the strain-relief problems with the MPM-1 ("T")-style MagSafe power cables, and issued settlement offer for buyers of Apple 60 W or 85 W MagSafe MPM-1 adapter within the first three years of purchase.[22]

Earlier power systems
Close-up view of the brick plug on the left, and the puck plug on the right, with tip ring sleeve plugs and a metal ring around the plug. The puck charger simply had a dark gray shroud, while the brick added the clear plastic charge indicator ring.

Before MagSafe, Apple laptop computers (like most non-Apple laptops) used a shell and socket/pin arrangement, or coaxial power connector. The iBook series introduced a charger that resembled a mini-stereo plug with an additional metal ring. The first puck-shaped iBook chargers simply had a silver plug body, but the square white chargers introduced a color-changing illuminated ring that indicated charging status.

Tripping on an iBook cord or yanking the cord out at an angle could bend the spring contacts inside the connector or break the solder pads under the connector, resulting in a laptop that would fail to charge when connected to the cord, or would only charge if the inserted plug were propped up or pushed down at an angle. An especially forceful yank could flare the outer flange or even break the tip of the power plug.

Replacing a damaged "DC-In Board" in an early 12 inch G3 iBook typically involved an expensive 50-step disassembly of the laptop.[23]

References

  1. ↑ "Apple Unveils New MacBook with Intel Core 2 Duo Processors" (press release). Apple Inc. November 8, 2006.
  2. ↑ Vallese, Julie (July 4, 2001). "'Break-Away' Cord Aims To Make Deep Fryers Safer". CNN. Retrieved July 9, 2012.
  3. ↑ News for "Break Away" Power Cords on Electric Deep Fryers
  4. ↑ Prior art for Apple's Magsafe – Patents Stack Exchange
  5. ↑ Fleishman, Glenn (12 March 2015). "Will your new MacBook crash to the ground without MagSafe? (Yes.)". Macworld. Retrieved 28 October 2016.
  6. ↑ Kastrenakes, Jacob (27 October 2016). "Apple is killing off MagSafe, one of the MacBook's best features". The Verge. Retrieved 28 October 2016.
  7. ↑ "MacBook Air - Technical Specifications". Apple Inc.
  8. ↑ "MacBook". Apple Inc.
  9. ↑ "Intel-Based Apple Portables: Identifying the Right Power Adapter and Power Cord – US". Apple Inc.
  10. ↑ "Apple MagSafe Airline Adapter". Apple Inc. Archived from the original on 2011-05-14.
  11. ↑ "One of Apple's Best Ideas Ever — Made Worse", The New York Times, July 30, 2012
  12. 1 2 3 Shirriff, Ken. "Teardown and exploration of Apple's Magsafe connector". Retrieved 3 December 2013.
  13. ↑ Frakes, Dan (June 15, 2007). "A Third-Party MagSafe Solution?". Mobile Mac (blog of Macworld). Retrieved July 9, 2012.
  14. ↑ "US District Court for the District of Northern California, Apple Inc. v Sanho Corporation" (PDF format).
  15. ↑ Cheng, Jacqui (October 18, 2010). "HyperMac To Halt MagSafe Sales, Hopes To Appease Apple – Sanho Corporation, Which Owns the Ever-popular HyperMac, Has Decided To Give …". Ars Technica. Retrieved July 9, 2012.
  16. 1 2 "MA538LL/B". Apple Inc. Archived from the original on 2008-02-19.
  17. ↑ Frakes, Dan (August 29, 2008). "Mac MagSaver Protects Your MagSafe Connector". Mobile Me (blog of Macworld). Retrieved July 9, 2012.
  18. ↑ Smykil, Jeff (August 20, 2008). "Some MagSafe Adapters Being Replaced by Apple – Apple Is Replacing Certain MagSafe Adapters That Have Proven Not To Be All …". Ars Technica. Retrieved July 9, 2012.
  19. ↑ Foresman, Chris (May 5, 2009). "Apple Sued over Reputed Fire Hazard of MagSafe Power Adapter – A Class Action Lawsuit Filed Last Week Claims Apple Has Been Negligent in …". Ars Technica. Retrieved July 9, 2012.
  20. ↑ "MacBook SMC Firmware Update 1.4". Knowledge Base. Apple Inc.
  21. ↑ https://www.apple.com/shop/mac/mac-accessories/power-cables
  22. ↑ Cheng, Jacqui (November 8, 2011). "Frayed MagSafe Power Connector? There's Now a Settlement for That – If You're an Owner of a T-Style MagSafe Connector That Has Frayed Through no …". Ars Technica. Retrieved July 9, 2012.
  23. ↑ "Installing iBook G3 12-Inch DC in Board" (repair guide). iFixIt.
  • "The Power of Magnets" (review). MacBook Pro. Ars Technica. , part of the Ars Technica review of the MacBook Pro dedicated to the MagSafe connector.
  • "Where Are the MagSafe Adapters for Cars and Airplanes?". ZDNet.
  • "MagSafe" (patent). Apple Inc.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.