Lightening holes

Aviation

Aircraft manufacturing in Australia 1943. Note the circular lightening holes in the wing ribs.

Lightening holes are often used in the aviation industry. This allows the aircraft to be lightweight as possible, retaining the durability and airworthiness of the aircraft structure.^[4][5]

Maritime

Lightening holes have also been used in marine engineering to increase seaworthiness of the vessel.^[6][7][8]

Motorsports

Car chassis with lightening holes, circa 1935.

Lightening holes became a prominent feature of motor racing in the 1920s and 1930s. Chassis members, suspension components, engine housings and even connecting rods were drilled with a range of holes, of sizes almost as large as the component.

"[The] wisdom of the day was to make everything along the lines of a brick shithouse [...] and then drill holes in the bits to lighten them."

— David Kelsey, Lotus Cars^[9]

This drive towards lightening was based on a misunderstanding of the component's mechanical behaviour. The assumption for an H-beam was that all of the resistance to bending stresses was carried in the two top and bottom flanges of the girder, with the central web only carrying out a spacing function. The central web could thus be drilled indiscriminately, supposedly without weakening the overall girder. This was based on two fallacies: firstly that the only forces on the beam were simple bending forces in the plane of the web. In practice, a more complicated force, such as an unexpected torsional twisting from a sudden suspension bump overloaded the now-weakened central web and the lightened beam failed immediately. Secondly, the assumption that the ideal forces were separated into the top and bottom flanges was increasingly unrealistic with the development of stressed skin and monocoque designs, where loads were more evenly shared. In these designs there was no "unloaded web" that could be safely drilled.

In comparison to aircraft design, it was notable that motor racing lightening was carried out after the design of the components, usually without understanding the forces in the structure and without re-performing any stress calculations afterwards. Owing to the increasing number of dangerous failures, the practice of drilling lightening holes was forbidden by the race scrutineers. Lightening was still permitted, but only where it had been specified by the original designers, not by simply drilling holes afterwards.

Military

Lightening holes have been used in various military vehicles, aircraft, equipment and weaponry platforms. This allows equipment to be lighter in weight as well as increase the ruggedness and duribility. They are usually made by drilling holes, pressed stamping or machining and can also save strategic materials and cost during wartime production.

Architecture

Parsons House is an example of the use of lightening holes in architecture.

Lightening holes have been used on various architecture designs.^[10] During the 1980s and early 1990s, Lightening holes were fashionable and somewhat seen as futuristic and were used in the likes of industrial units, car showrooms, shopping precincts, sports centres etc. Parsons House in London is a notable building that uses lightening holes since its renovation in 1988.^[11][12][13] Ringwood Health & Leisure Centre in Hampshire is another notable example.^[14][15]