ethtool

ethtool
Original author(s) David S. Miller
Developer(s) Ben Hutchings
Initial release 1998 (1998)
Repository
Edit this at Wikidata
Written in C
Operating system Linux
Type Utility program
License GNU GPL v2
Website www.kernel.org/pub/software/network/ethtool/

ethtool is a utility for Linux kernel-based operating system for displaying and modifying some parameters of network interface controllers (NICs) and their device drivers. ethtool is developed parallel to the Linux kernel.

Usage

The command is useful for

  • Identification and diagnosis of Ethernet devices
  • Extended Ethernet devices statistics
  • Control speed, duplex, auto-negotiation and flow control for Ethernet devices
  • Control checksum offload and other hardware offload features
  • Control DMA ring sizes and interrupt moderation
  • Control receive queue selection for multiqueue devices
  • Upgrade firmware in flash memory

Examples

To display the current parameters of the first network port ( eth0):

$ ethtool eth0
Settings for eth0:
       Supported ports: [ TP MII ]
       Supported link modes:   10baseT/Half 10baseT/Full
                               100baseT/Half 100baseT/Full
       Supports auto-negotiation: Yes
       Advertised link modes:  10baseT/Half 10baseT/Full
                               100baseT/Half 100baseT/Full
       Advertised auto-negotiation: No
       Speed: 100Mb/s
       Duplex: Full
       Port: MII
       PHYAD: 1
       Transceiver: internal
       Auto-negotiation: off
       Supports Wake-on: g
       Wake-on: g
       Current message level: 0x00000007 (7)
       Link detected: yes

To force its speed and duplex, in 1000BASE-T:

$ ethtool -s eth0 speed 1000 duplex full autoneg off

See also


This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.