Absorbed dose
Absorbed dose of ionizing radiation | |
---|---|
Common symbols | D |
SI unit | Gray |
Other units | Rad, Erg |
In SI base units | J⋅kg−1 |
Absorbed dose is a measure of the energy deposited in a medium by ionizing radiation. The unit of measure derived from the SI system is the gray (Gy), which is defined as one Joule of energy absorbed per per kilogram of matter.[1] Absorbed dose is used in the calculation of dose uptake in living tissue in both radiation protection (reduction of harmful effects), and radiology (potential beneficial effects for example in cancer treatment). It is also used to directly compare the effect of radiation on inanimate matter.
The non-SI CGS unit rad is sometimes also used, predominantly in the USA.
Stochastic risk
The quantity absorbed dose is of importance in radiation protection for calculating radiation dose. However, absorbed dose is a physical quantity and used unmodified is not an adequate indicator of the likely health effects in humans. For stochastic radiation risk (defined as the probability of cancer induction and genetic effects) consideration must be given to the type of radiation and the sensitivity of the irradiated tissues which requires the use of modifying factors.
To represent stochastic risk the equivalent dose H T and effective dose E are used, and appropriate dose factors and coefficients are used to calculate these from the absorbed dose.[2] Equivalent and effective dose quantities are expressed in units of the sievert or rem which implies that biological effects have been taken into account. The derivation of stochastic risk is in accordance with the recommendations of the International Committee on Radiation Protection (ICRP) and International Commission on Radiation Units and Measurements (ICRU). The coherent system of radiological protection quantities developed by them is shown in the accompanying diagram.
Deterministic effects
Conventionally, unmodified absorbed dose is not used for comparing stochastic risks but only for acute dose giving rise to tissue effects, such as in acute radiation syndrome.
Effects of acute radiation exposure
Phase | Symptom | Whole-body absorbed dose (Gy) | ||||
---|---|---|---|---|---|---|
1–2 Gy | 2–6 Gy | 6–8 Gy | 8–30 Gy | > 30 Gy | ||
Immediate | Nausea and vomiting | 5–50% | 50–100% | 75–100% | 90–100% | 100% |
Time of onset | 2–6 h | 1–2 h | 10–60 min | < 10 min | Minutes | |
Duration | < 24 h | 24–48 h | < 48 h | < 48 h | N/A (patients die in < 48 h) | |
Diarrhea | None | None to mild (< 10%) | Heavy (> 10%) | Heavy (> 95%) | Heavy (100%) | |
Time of onset | — | 3–8 h | 1–3 h | < 1 h | < 1 h | |
Headache | Slight | Mild to moderate (50%) | Moderate (80%) | Severe (80–90%) | Severe (100%) | |
Time of onset | — | 4–24 h | 3–4 h | 1–2 h | < 1 h | |
Fever | None | Moderate increase (10–100%) | Moderate to severe (100%) | Severe (100%) | Severe (100%) | |
Time of onset | — | 1–3 h | < 1 h | < 1 h | < 1 h | |
CNS function | No impairment | Cognitive impairment 6–20 h | Cognitive impairment > 24 h | Rapid incapacitation | Seizures, tremor, ataxia, lethargy | |
Latent period | 28–31 days | 7–28 days | < 7 days | None | None | |
Symptom | Mild to moderate Leukopenia Fatigue Weakness |
Moderate to severe Leukopenia Purpura Hemorrhage Infections Alopecia after 3 Gy |
Severe leukopenia High fever Diarrhea Vomiting Dizziness and disorientation Hypotension Electrolyte disturbance |
Nausea Vomiting Severe diarrhea High fever Electrolyte disturbance Shock |
N/A (patients die in < 48h) | |
Mortality | Without care | 0–5% | 5–95% | 95–100% | 100% | 100% |
With care | 0–5% | 5–50% | 50–100% | 99–100% | 100% | |
Death | 6–8 weeks | 4–6 weeks | 2–4 weeks | 2 days – 2 weeks | 1–2 days | |
Table Source[3] |
Radiation therapy
The measurement of absorbed dose in tissue is of fundamental importance in radiobiology as it is the measure of the amount of energy the incident radiation is imparting to the target tissue.
Dose Computation
The absorbed dose is equal to the radiation exposure (ions or C/kg) of the radiation beam multiplied by the ionization energy of the medium to be ionized.
For example, the ionization energy of dry air at 20 °C and 101.325 kPa of pressure is ±0.06 J/C. 33.97[4]:305 (33.97 eV per ion pair) Therefore, an exposure of ×10−4 C/kg (1 2.58roentgen) would deposit an absorbed dose of ×10−3 J/kg (0.00876 8.76 Gy or 0.876 rad) in dry air at those conditions.
When the absorbed dose is not uniform, or when it is only applied to a portion of a body or object, an absorbed dose representative of the entire item can be calculated by taking a mass-weighted average of the absorbed doses at each point.
More precisely,[5]
Where
- is the mass-averaged absorbed dose of the entire item T
- is the item of interest
- is the absorbed dose as a function of location
- is the density as a function of location
- is volume
Medical considerations
Non-uniform absorbed dose is common for soft radiations such as low energy x-rays or beta radiation. Self-shielding means that the absorbed dose will be higher in the tissues facing the source than deeper in the body.
The mass average can be important in evaluating the risks of radiotherapy treatments, since they are designed to target very specific volumes in the body, typically a tumour. For example, if 10% of a patient's bone marrow mass is irradiated with 10 Gy of radiation locally, then the absorbed dose in bone marrow overall would be 1 Gy. Bone marrow makes up 4% of the body mass, so the whole-body absorbed dose would be 0.04 Gy. The first figure (10 Gy) is indicative of the local effects on the tumour, while the second and third figure (1 Gy and 0.04 Gy) are better indicators of the overall health effects on the whole organism. Additional dosimetry calculations would have to be performed on these figures to arrive at a meaningful effective dose, which is needed to estimate the risk of cancer or other stochastic effects.
When ionizing radiation is used to treat cancer, the doctor will usually prescribe the radiotherapy treatment in units of gray. Medical imaging doses may be described in units of coulomb per kilogram, but when radiopharmaceuticals are used, they will usually be administered in units of becquerel.
Other uses
Absorbed dose is also used to manage the irradiation and measure the effects of ionising radiation on inanimate matter in a number of fields.
Component survivability
Absorbed dose is used to rate the survivability of devices such as electronic components in ionizing radiation environments.
Radiation hardening
The measurement of absorbed dose absorbed by inanimate matter is vital in the process of radiation hardening which improves the resistance of electronic devices to radiation effects.
Food irradiation
Absorbed dose is the physical dose quantity used to ensure irradiated food has received the correct dose to ensure effectiveness. Variable doses are used depending on the application and can be as high as 70 kGy.
Radiation-related quantities
The following table shows radiation quantities in SI and non-SI units:
Quantity | Unit | Symbol | Derivation | Year | SI equivalence |
---|---|---|---|---|---|
Activity (A) | curie | Ci | 3.7 × 1010 s−1 | 1953 | 3.7×1010 Bq |
becquerel | Bq | s−1 | 1974 | SI | |
rutherford | Rd | 106 s−1 | 1946 | 1,000,000 Bq | |
Exposure (X) | röntgen | R | esu / 0.001293 g of air | 1928 | 2.58 × 10−4 C/kg |
Fluence (Φ) | (reciprocal area) | m−2 | 1962 | SI | |
Absorbed dose (D) | erg | erg⋅g−1 | 1950 | 1.0 × 10−4 Gy | |
rad | rad | 100 erg⋅g−1 | 1953 | 0.010 Gy | |
gray | Gy | J⋅kg−1 | 1974 | SI | |
Dose equivalent (H) | röntgen equivalent man | rem | 100 erg⋅g−1 | 1971 | 0.010 Sv |
sievert | Sv | J⋅kg−1 × WR | 1977 | SI |
Although the United States Nuclear Regulatory Commission permits the use of the units curie, rad, and rem alongside SI units,[6] the European Union European units of measurement directives required that their use for "public health ... purposes" be phased out by 31 December 1985.[7]
See also
- kerma (physics)
- Mean glandular dose
- Category:Units of radiation dose
References
- ↑ ICRP 2007, glossary.
- ↑ ICRP 2007, paragraphs 104 and 105.
- ↑ "Radiation Exposure and Contamination - Injuries; Poisoning - Merck Manuals Professional Edition". Merck Manuals Professional Edition. Retrieved 2017-09-06.
- ↑ Podgorsak, E. B., ed. (2005). Radiation Oncology Physics: A Handbook for Teachers and Students (PDF). Vienna: International Atomic Energy Agency. ISBN 92-0-107304-6. Retrieved 25 November 2012.
- ↑ ICRP 2007, p. 1.
- ↑ 10 CFR 20.1004. US Nuclear Regulatory Commission. 2009.
- ↑ The Council of the European Communities (1979-12-21). "Council Directive 80/181/EEC of 20 December 1979 on the approximation of the laws of the Member States relating to Unit of measurement and on the repeal of Directive 71/354/EEC". Retrieved 19 May 2012.
Literature
- ICRP (2007). "The 2007 Recommendations of the International Commission on Radiological Protection". Annals of the ICRP. ICRP publication 103. 37 (2–4). ISBN 978-0-7020-3048-2. Retrieved 17 May 2012.
External links
- Specific Gamma-Ray Dose Constants for Nuclides Important to Dosimetry and Radiological Assessment, Laurie M. Unger and D. K . Trubey, Oak Ridge National Laboratory, May 1982 - contains gamma-ray dose constants (in tissue) for approximately 500 radionuclides.