Micro Engineering Solutions, Inc.

Micro Engineering Solutions, Inc.[1] was a CAD/CAM (Computer Aided Design / Computer Aided Manufacturing) software company founded in 1986 by Lynn and Jim Hock and Bill Harris in Farmington, Michigan. The initial product was "Solution 3000", a PC based CAD/CAM system that ran on a standard IBM PC "AT" (or clone), running under IBM PC DOS, with 640kb of memory. Additional required hardware included a math coprocessor, a 20MB hard disk drive with floppy disk backup, a graphics display interface, and a graphics monitor.

Solution 3000 featured true full 3D modeling capability, including both design and manufacturing capabilities. Optional packages included:

Advanced Surfacing / NC Machining Advanced Conversion Programs: IGES (Initial Graphics Exchange Specification), DFX (AutoCAD Format),[2] DES (General Motors), Ford Standard Tape, and Chrysler's format.

In 1990, Micro Engineering Solutions, Inc. was purchased by a group of investors that included Morganthaler Ventures, 3I Ventures, and GeoCapital.[3]

In 1991, the Board appointed Ken Spenser as President and CEO.[4]

On October 19, 1992, Autodesk Inc, Sausalito CA acquired Micro Engineering Solutions.[5]

References

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.