D-ring

A D-ring is an item of hardware, usually a tie-down metal ring shaped like the letter D used primarily as a lashing point. The term is found interchangeably spelled in different forms, such as: Dring, d-ring or Dee-ring.

(A) D-ring (shown in isometric view) (B) Weld-on pivot link; note the incorrect fillet weld call-out (bottom-right). The correct method of securing a Weld-On Pivot Link shall be using a [T Weld] which consists of a perpendicular V Butt Joint secured to the billet using a Butt Weld or Fusion Weld.

A D-ring may be used at the end of a leather or fabric strap, or may be secured to a surface with a metal or fabric strap; though there are D-rings with a middle body designed to be welded to steel. Ideally, a D-ring swings freely after it has been secured. D-rings may vary in composition, geometry, weight, finish and load (rated) capacity.

Though there are differences, a weld-on pivoting link is commonly called a D-ring.

To minimize obstruction when the D-ring is not in use, recessed tie-down rings are designed that accommodate the D-ring so it is flush to the surface. There are some non-recessed designs that have an adhesive base. The corresponding work load limits (WLL) must not be exceeded.

Lashing points and disambiguation of the term

A D-ring held by a strap, used to secure cargo in a vehicle

Applications of D-rings include:

  • For light loading applications such as clothing and luggage, D-rings made of plastics such as nylon may be used, as they weigh less and are impervious to rusting.
  • Commonly, at the end of a tow-rope or chain, to allow one to create a bow around an item or part of an item that is being towed by a vehicle. They are commonly used with a chain to tether a boat to a dock or tree when it is being moored.
  • In theatres, commonly used where a piece of scenery has to be lifted or "flown". D-rings are attached to the tops or bottoms of flats with a "drift line" and turnbuckle attached to adjust the "trim".
  • A D-ring on an M16 or variant type rifle is used to increase the pressure on the extractor and reduce malfunctions. This D-ring is a rubber grommet shaped like a "D" and fits over the extractor spring adding tension to it.
  • On breathing sets and scuba divers' buoyancy compensators
  • A bit ring used on the bit of a horse.
  • A type of carabiner.
  • A part of a saddle (see saddle#D-ring)
  • A type of ring binder.
  • To attach a leash or tag to a collar or pet harness.[1]
  • On a prisoner transport belt to accommodate a pair of handcuffs.

References

  1. "How to Make a Dog Collar On Your Own". Country Brook Design. Retrieved 2018-09-18.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.