Bit banging

In computer engineering and electrical engineering, bit banging is slang for any method of data transmission that employs software as a substitute for dedicated hardware to generate transmitted signals or process received signals. Software directly sets and samples the states of GPIOs (e.g., pins on a microcontroller), and is responsible for meeting all timing requirements and protocol sequencing of the signals. In contrast to bit banging, dedicated hardware (e.g., UART, SPI interface) satisfies these requirements and, if necessary, provides a data buffer to relax software timing requirements. Bit banging can be implemented at very low cost, and is commonly used in embedded systems.[1]

Bit banging allows a device to implement different protocols with minimal or no hardware changes. In some cases, bit banging is made feasible by newer, faster processors because more recent hardware operates much more quickly than hardware did when standard communications protocols were created.

C code example

The following C language code example transmits a byte of data on an SPI bus.

// transmit byte serially, MSB first
void send_8bit_serial_data(unsigned char data)
{
   int i;

   // select device (active low)
   output_low(SD_CS);

   // send bits 7..0
   for (i = 0; i < 8; i++)
   {
       // consider leftmost bit
       // set line high if bit is 1, low if bit is 0
       if (data & 0x80)
           output_high(SD_DI);
       else
           output_low(SD_DI);

       // pulse the clock state to indicate that bit value should be read
       output_low(SD_CLK);
       delay();
       output_high(SD_CLK);

       // shift byte left so next bit will be leftmost
       data <<= 1;
   }

   // deselect device
   output_high(SD_CS);
}

Considerations

The question whether to deploy bit banging or not is a trade-off between load, performance and reliability on the one hand, and the availability of a hardware alternative on the other. The software emulation process consumes more processing power than does supporting dedicated hardware. The microcontroller spends much of its time sending or receiving samples to and from the pins, at the expense of other tasks. The signal produced usually has more jitter or glitches, especially if the processor is also executing other tasks while communicating. However, if the bit-banging software is interrupt-driven by the signal, this may be of minor importance, especially if control signals such as RTS, CTS, or DCD are available. The implementation in software can be a solution when specific hardware support is not available or requires a more expensive microcontroller.

References

Predko, Michael (2000). Programming and customizing PICmicro microcontrollers (2nd ed.). McGraw-Hill Professional. pp. 10–12. ISBN 978-0-07-136172-9.

External links

Asynchronous serial (RS-232)

I²C bus

I2C on AVR using bit banging

SPI bus

Efficient bit-banged SPI for 8051 microcontroller

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.

[Predko_2000-1] Predko, Michael (2000). Programming and customizing PICmicro microcontrollers (2nd ed.). McGraw-Hill Professional. pp. 10–12. ISBN 978-0-07-136172-9.

Bit banging

C code example

Considerations

See also

References

External links